Detalles del producto

Características del producto

The Audio-Technica AT-OC9XML is a dual moving coil phono cartridge with a nude Microlinear stylus on a 0.28 mm nude boron cantilever, built for low distortion and fast transient response. Independent PCOCC coils for each channel, arranged in a reverse-V layout, give strong channel separation.

A rigid aluminum body limits resonance, and a neodymium magnet with permendur yoke concentrates the field in the coil gap. The pre-threaded body mounts with two screws and no nuts on any half-inch headshell. With 0.4 mV output it requires a phono stage or step-up with an MC input; the stylus is not field-replaceable.

Key Features:

  • Dual moving coil design with independent PCOCC coils per channel
  • Nude Microlinear stylus (2.2 × 0.12 mil) on 0.28 mm nude boron cantilever
  • Frequency response 20 – 47,000 Hz
  • Aluminum body to reduce unwanted resonance
  • Neodymium magnet and permendur yoke
  • Threaded body for nut-free half-inch mounting
  • Brass terminal pins

Especificaciones del producto

Audio-Technica AT-OC9XML — Dual Moving Coil Cartridge with Microlinear Stylus

  • Type: Dual moving coil (MC)
  • Frequency Response: 20 – 47,000 Hz
  • Output Voltage: 0.4 mV (1 kHz, 5 cm/sec)
  • Channel Separation: 27 dB (1 kHz)
  • Output Channel Balance: 1.0 dB (1 kHz)
  • Vertical Tracking Force: 1.8 – 2.2 g (2.0 g standard)
  • Vertical Tracking Angle: 20°
  • Stylus: Nude square shank Microlinear, 2.2 × 0.12 mil
  • Cantilever: 0.28 mm diameter nude boron
  • Static / Dynamic Compliance: 20 × 10-6 cm/dyne / 16 × 10-6 cm/dyne (100 Hz)
  • Coil Impedance / DC Resistance: 12 Ω (1 kHz) / 12 Ω
  • Recommended Load Impedance: Min. 100 Ω (with head amplifier)
  • Coil Wire / Body: PCOCC / Aluminum
  • Mounting: Half-inch, threaded body
  • Dimensions: 17.3 mm (0.68″) H × 16.8 mm (0.66″) W × 25.7 mm (1.01″) D
  • Weight: 7.6 g (0.3 oz)
  • MPN: AT-OC9XML  ·  UPC: 4961310150426

Qué incluye

- AT-OC9XML dual moving coil cartridge
- Non-magnetic screwdriver
- Washers x 2
- Cartridge installation screws: 5 mm x 2, 8 mm x 2, 10 mm x 2, 12 mm x 2
- Plastic protector
- Brush

Documentación