Audio-Technica AT-VM95E/H - Elliptical Cartridge Pre-Mounted on AT-HS6 Headshell

The AT-VM95E/H is Audio-Technica's AT-VM95E dual moving magnet cartridge supplied pre-mounted on the AT-HS6BK universal headshell. It is ready to install on any turntable with a standard 4-pin, ½″-mount headshell tonearm.

The AT-VM95E uses a 0.3 × 0.7 mil elliptical bonded stylus on an aluminum pipe cantilever, with threaded inserts in the body so it mounts with two screws and no nuts. Its stylus can be swapped for any AT-VMN95 replacement stylus.

Key Features:

• AT-VM95E VM dual magnet cartridge pre-mounted on AT-HS6BK headshell
• 0.3 × 0.7 mil elliptical stylus, bonded round shank
• Aluminum pipe cantilever
• Specially wound coils for 4.0 mV output
• Low-resonance polymer housing with threaded inserts
• Compatible with any AT-VMN95 replacement stylus (AT-VMN95E standard)
• Universal ½″-mount headshell for 4-pin tonearms

Audio-Technica AT-VM95E/H — Elliptical Cartridge Pre-Mounted on AT-HS6 Headshell

• Type: VM stereo dual magnet cartridge on AT-HS6BK headshell
• Frequency Response: 20 – 22,000 Hz
• Output Voltage: 4.0 mV (1 kHz, 5 cm/sec.)
• Channel Separation: 20 dB (1 kHz)
• Output Channel Balance: 2.0 dB (1 kHz)
• Vertical Tracking Force: 1.8 – 2.2 g (2.0 g standard)
• Vertical Tracking Angle: 23°
• Stylus: 0.3 × 0.7 mil elliptical, bonded round shank
• Cantilever: Aluminum pipe
• Static / Dynamic Compliance: 17 × 10^-6 cm/dyne / 7 × 10^-6 cm/dyne (100 Hz)
• Coil Impedance / DC Resistance / Inductance: 3.3 kΩ (1 kHz) / 485 Ω / 550 mH (1 kHz)
• Recommended Load: 47,000 Ω, 100 – 200 pF
• Mounting: Half-inch
• Replacement Stylus: AT-VMN95E
• Weight: Cartridge 6.1 g (0.22 oz); cartridge & headshell 15.5 g (0.55 oz)
• MPN: AT-VM95E/H  ·  UPC: 4961310157333

- AT-VM95E cartridge pre-mounted on AT-HS6BK headshell
- Two 11 mm installation screws
- Two 8 mm installation screws
- Two washers

Safety Data Sheet (PDF)